SMART Board SB640 Installation And User Manual page 20

Chapter 2
Installing and securing your interactive whiteboard
Aligning your interactive whiteboard with your projector
If your projector is installed in a fixed location, align your interactive whiteboard to the projected image
before you secure the L-shaped brackets. A correctly aligned image fits squarely on your interactive
whiteboard's screen. Each side of the projected image should extend almost to the edge of the display
surface.
IMPORTANT
For SMART Board D600 series interactive whiteboards, it is important to align your interactive
whiteboard and projector correctly so that the projected image divider in dual-user mode in SMART
Notebook software aligns with the physical center of your interactive whiteboard. The actual divider will
always be in the physical center of your interactive whiteboard, regardless of where your projected
image falls.
To align your interactive whiteboard with your projector
1. Install or position your projector on a projector platform or stand if necessary, and then turn it on and
point the lens of your projector at the center of your interactive whiteboard's screen.
2. Make fine adjustments to the image size, level and focus of the projected image, following your
projector manufacturer's instructions.
3. Slide your interactive whiteboard sideways on its bracket to align it with the projected image.
4. Repeat steps 2 and 3 until your interactive whiteboard is properly aligned.
Completing your installation
Refer to the following procedure to finish installing your interactive whiteboard.
smarttech.com/kb/001414 20