Table of Contents
Advertisement
VIPA HMI Touch Panel
3.2 Installation of the optional MPI/PROFIBUS DP interface
Installation
HB160 | TP-ECO | 62P-NHC0 | GB | 13-45
+
DC 24V
-
DC 0V
PE Protective earth
CAUTION!
Personnel and instruments should be grounded when
working on electrostatic sensitive modules! Take the inter-
face module only at the holding plate and avoid touching
the board! Store respectively send the interface module
always in the corresponding ESD packaging!
1.
Remove the cover plate of the COM3 port by removing the
screws and pulling the plate.
2.
For installation insert the interface module into the opening.
Push the interface module in the device until the holding plate
fits to the housing. Here the interface module is put into the right
position by 2 inner guide rails.
Deployment Touch Panel
Installation of the optional MPI/PROFIBUS DP interface
21
Advertisement
Table of Contents
