Table of Contents
Advertisement
VIPA HMI
3
Deployment Touch Panel
3.1 Installation
Overview
Installation cutting
Installation
HB160 | TP | 62I-JID0 | GB | 15-36
The Touch Panel is suitable for the installation in operating tables and
control cabinet fronts. The installation happens via the back. The
Touch Panel is provided with a patented integrated fixing technique
that allows an easy connection with a simple screwdriver.
Due to the fact that the Touch Panel has a plug connector for bus
connection and voltage supply, a fast and easy device change is pos-
sible.
For the installation into a operating tableau and control cabinet fronts,
the Touch Panel requires the following front plate cutting:
Touch Panel
62I-JID0-...
The fixing technique is integrated in the casing of the Touch Panel
and accessible via the back. For the installation, a small slit screw-
driver is required
1.
Push the operator panel [3] from the front side into the front
panel cutting [1] until it touches the panel with the seal [2].
2.
Now bolt the lever [5] clockwise with the screwdriver [4] until it
rotates to the outside.
3.
Further screwing bolts the lever to the front panel until it holds
this to the control cabinet front.
Deployment Touch Panel
W x H in mm
250 x 175
Installation
23
Advertisement
Table of Contents
