Deployment Panel Pc; Installation - YASKAWA VIPA HMI PPC021 CE Manual

VIPA HMI PPC021 CE
3

Deployment Panel PC

3.1 Installation

Overview
Installation cutting
Installation
HB160 | PPC | 67S-PNJ0 | GB | 15-30
The Panel PC is suitable for the installation in operating tables and
control cabinet fronts. The installation happens via the back. The
Panel PC is provided with a fixing technique with not losable screws
that allows an easy connection with a crosstip screwdriver. A fast and
easy device change is possible. It is also possible to install the Panel
PC in a VESA holder (100mm x 100mm).
For the installation into a operating tableau and control cabinet fronts,
the Panel PC requires the following front panel cutting:
Panel PC
67S-PNJ0-...
The material thickness of the installation cut-out is 3 ...
12mm.
For the installation of the panel pivoted lever are integrated. For the
installation, a small slit screwdriver is required.
1. Push the Panel PC [3] from the front side into the front panel
cutting [1] until it touches the panel with the seal [2].
2. Rotate the pivoted lever 90 degrees to the outside [4].
3. Screw the screws with the crosstip screwdriver [5].
Deployment Panel PC
W x H in mm
547 x 367mm
Installation
21