Deployment Panel Pc; Installation - YASKAWA 67S-RTP0-KB Manual

Deployment Panel PC

Installation

3 Deployment Panel PC
3.1 Installation
Overview
Installation cutting
Installation
22
The Panel PC is suitable for the installation in operating tables and control cabinet fronts.
The installation happens via the back. The Panel PC is provided with a fixing technique
with not losable screws that allows an easy connection with a crosstip screwdriver. A fast
and easy device change is possible. It is also possible to install the Panel PC in a VESA
holder (VESA 75/100).
For the installation into a operating tableau and control cabinet fronts, the Panel PC
requires the following front panel cutting:
Panel PC
67S-RTP0-KB
The material thickness of the installation cut-out is 3 ... 12mm.
For the installation of the panel pivoted lever are integrated. For the installation, a crosstip
screwdriver is required.
1. Push the Panel PC [3] from the front side into the front panel cutting [1] until it
touches the panel with the seal [2].
2. Rotate the pivoted lever 90 degrees to the outside [4].
3. Screw the screws with the crosstip screwdriver [5].
W x H in mm
547 x 367mm
HB160 | PPC | 67S-RTP0-KB | en | 23-20
HMI