Table of Contents
Advertisement
Preparing for installation
Safety recommendations
To avoid any equipment damage or bodily injury caused by improper use, read the following safety
recommendations before installation. Note that the recommendations do not cover every possible
hazardous condition.
Before cleaning the switch, unplug all power cords from the switch. Do not clean the switch with wet
•
cloth or liquid.
Do not place the switch near water or in a damp environment. Prevent water or moisture from
•
entering the switch chassis.
Do not place the switch on an unstable case or desk. The switch might be severely damaged in case
•
of a fall.
•
Ensure proper ventilation of the equipment room and keep the air inlet and outlet vents of the switch
free of obstruction.
Connect the yellow-green protection grounding cable before power-on.
•
Make sure that the operating voltage is in the required range.
•
To avoid electrical shocks, do not open the chassis while the switch is operating or when the switch
•
is just powered off.
When replacing transceiver modules, wear an ESD-preventive wrist strap to avoid damaging the
•
units.
Examining the installation site
The HP 3100-48 v2 Switch must be used indoors. You can mount the switch in a rack or on a workbench,
but make sure:
Adequate clearance is reserved at the air inlet and exhaust vents for ventilation.
•
The rack or workbench has a good ventilation system.
•
•
The rack is sturdy enough to support the switch and its accessories.
The rack or workbench is well earthed.
•
To ensure normal operation and long service life of your switch, install it in an environment that meets the
requirements described in the following subsections.
Temperature/humidity
Maintain appropriate temperature and humidity in the equipment room.
Lasting high relative humidity can cause poor insulation, electricity creepage, mechanical property
•
change of materials, and metal corrosion.
Lasting low relative humidity can cause washer contraction and ESD and bring problems including
•
loose captive screws and circuit failure.
2
Advertisement
Table of Contents
