Preparing For Installation; Safety Recommendations - HP 1420 Series Getting Started Manual

Preparing for installation

The HP 1420 Gigabit Ethernet Switch Series includes models listed in
Table 1 HP 1420 Gigabit Ethernet Switch Series models
Product code
Non-PoE
JH016A
JH017A
JH018A
PoE
JH019A
IMPORTANT:
For regulatory identification purposes, the switches are assigned Regulatory Model Numbers (RMNs). The
RMNs should not be confused with the marketing name HP 1420, or the product codes.

Safety recommendations

To avoid any equipment damage or bodily injury, read the following safety recommendations before
installation. The recommendations do not cover every possible hazardous condition.
To avoid damage to the electrolytic capacitor in the switch, do not store the switch without power for
•
more than one year.
Before cleaning the switch, remove all power cords from the switch. Do not clean the switch with a
•
wet cloth or liquid.
Do not place the switch near water or in a damp environment. Prevent water or moisture from
•
entering the switch chassis.
Do not place the switch on an unstable case or desk. The switch might be severely damaged in case
•
of a fall.
• Ensure good ventilation of the equipment room and keep the air inlet and outlet vents of the switch
free of obstruction.
Make sure the operating voltage is in the required range.
•
To avoid electrical shocks, do not open the chassis while the switch is operating or when the switch
•
is just powered off.
The accessories shipped with the switch, including but not limited to power cables, are intended
•
only for the switch. Please do not use them for other products.
HP description
HP 1420-16G Switch
HP 1420-24G-2SFP Switch
HP 1420-24G-2SFP+ 10G Uplink
Switch
HP 1420-24G-PoE+ (124W) Switch
Alias
1420-16G
1420-24G-2SFP
1420-24G-2SFP+ 10G Uplink
1420-24G-PoE+ (124W)
1
Table 1.
RMN
HNGZA-HA0020
HNGZA-HA0021
HNGZA-HA0022
HNGZA-HA0023