14.3
Removing the rear wheel
–
Clean the thread of the wheel spindle and screw
–
Clean and grease wheel spindle.
Long-life grease (
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel
spindle
–
Position wheel speed sensor
–
Mount and tighten screw
Guideline
Screw, wheel speed
sensor holder
–
Mount and tighten screws
Guideline
F00754-11
Screw, front fender
–
Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
–
Take the motorcycle off the front lifting gear. (
–
Remove the rear of the motorcycle from the lifting gear.
(
p. 54)
–
Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
Tighten screws
Guideline
Screw, fork stub
Preparatory work
–
Raise the motorcycle with the rear lifting gear. (
Main work
–
Remove screw
F00776-10
p. 115)
2
.
M8
25 Nm (18.4 lbf ft)
3
in the hole.
4
.
M6
8 Nm (5.9 lbf ft)
5
with the washers.
M6
7 Nm (5.2 lbf ft)
6
.
M8
15 Nm (11.1 lbf ft)
1
.
WHEELS, TIRES 14
2
.
p. 55)
p. 54)
71