Table of Contents
Advertisement
18.1
Checking the engine oil level
18.2
Changing the engine oil and oil filter, cleaning the oil screen
Warning
Danger of scalding Engine and gear oil get very hot when the motorcycle is ridden.
–
Wear suitable protective clothing and safety gloves.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with
the applicable regulations.
Info
Drain the engine oil while the engine is at operating temperature.
Condition
The engine is at operating temperature.
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
Main work
–
Check the engine oil level.
Info
After switching off the engine, wait one minute before
checking the level.
The engine oil must be between the markings
»
If the engine oil is below the marking
F00772-10
–
Add engine oil. (
»
If the engine oil is above the marking
–
Correct the engine oil level.
Preparatory work
–
Remove the front spoiler. (
–
Stand the motorcycle on a level surface using the side stand.
Main work
–
Place an appropriate container under the engine.
–
Remove oil drain plug
–
Remove oil screen
–
Allow the engine oil to drain completely.
–
Clean the oil drain plug and the oil screen thoroughly.
–
Position oil screen
1
plug
with the O-ring.
S04689-10
Guideline
Oil drain plug
SERVICE WORK ON THE ENGINE 18
A
p. 97)
B
p. 61)
1
with the O-ring.
2
with the O-ring.
2
and mount and tighten oil drain
M24x1.5
15 Nm (11.1 lbf ft)
A
B
and
.
:
:
95
Advertisement
Table of Contents
