Table of Contents
Advertisement
Inlet Arm Assembly Installation
Position the Inlet Arm Assembly (Item #2) over the Chassis Frame Assembly's (Item #1) Base Frame Cross Support.
See Figure A. Secure the Inlet Arm Assy by using (3) 3/8"-16 x 1" Carriage Bolts (Item #3), (3) 3/8"-16 Flange Nuts
(Item #4) and (3) 3/8" Flat Washers (Item #5). Refer to Figure A.
Note: Some parts and part features have been hidden from view for visual clarity.
Figure A
Swivel Inlet Assembly Installation
Position the Swivel Inlet Assembly (Item #1) and Foam Seal (Item #5) into the Blower Inlet, as shown in Figure B.
Install the Swivel Inlet Assy into the Inlet Arm Assy (Item #2) by securing the Swivel Inlet Assy using (1) 3/8"-16 x 2"
HHCS (Item #3) and (1) 3/8"-16 Flange Nut (Item #4), refer to Figure C.
Note: Some parts and part features have been hidden from view for visual clarity.
Figure B
18
Figure C
Advertisement
Table of Contents
