Wiring Harness Installation - Peco Estate 795001 Operator's Manual

Wiring Harness Installation

To connect the Wiring Kit P#(A2152), connect the 4 gage Red Wire P#(P0620) to the positive (+) terminal of the
starter solenoid on the engine. Route the Red Wire from the solenoid to the positive (+) terminal of the battery.
Connect the 4 gage Black Wire P#(P0621) to one of the mounting bolt holes located on the bottom of the engine.
Route the black wire from the bolt hole to the negative (-) terminal of the battery.
Refer to the Figures below for your respective engine.
Once the wires are properly routed, test start the engine. If working properly, secure the wiring with the provided Zip
Ties P#(J0245).
10HP / 14HP / 16HP Vanguard
Positive (+) Terminal
Connection (Solenoid)
7HP Yanmar
26
Positive
Negative (-) Terminal
Connection
(Engine Block)
Negative (-) Terminal
Connection
(Engine Block)