Wiring Kit Installation - Peco Estate 793604 Operator's Manual

Wiring Harness Installation
To connect the Wiring Kit (P#A2152), connect the 4 gage Red Wire (P#P0620) to the positive (+) terminal of the
starter solenoid on the engine. Route the Red Wire from the solenoid to the positive (+) terminal of the battery.
Connect the 4 gage Black Wire (P#P0621) to one of the mounting bolt holes located on the bottom of the engine.
Route the black wire from the bolt hole to the negative (-) terminal of the battery. Refer to Figure B.
Once the wires are properly routed, test start the engine. If working properly, secure the wiring with the provided Zip
Ties (P#J0245).
10HP / 14HP / 16HP Vanguard
Positive (+) Terminal
Connection (Solenoid)
Pasture Vac Unit Instructions
To connect the Wiring Harness, connect the 10 gage Red Wire P#(P0278) from the positive (+) terminal of the battery
to the positive (+) terminal of the starter solenoid located on the front end of the engine. Then connect the 10 gage
Black Wire P#(P0279) from the negative (-) terminal of the battery to one of the mounting bolt holes located on the
bottom of the engine or one of the bolt holes located on the Engine Mount Arm.
Refer to the Figure Below
Universal Battery Kit P#(A2326)
26
Positive (+) Terminal
Connection (Solenoid)
Negative (-) Terminal
Connection
(Engine Block)
Negative (-) Terminal
Connection
(Engine Mount Arm)