Mercury SmartCraft Systems Monitor Operation Manual page 7

Initial Power Up (Or After Master Reset)
INITIAL AUTO-DETECTION ERROR MESSAGES:
BASIC OPERATION
Flashing "Stbd" – More than one of
the engine computers (ECMs) are
configured as a starboard engine.
The engines must be programmed
for proper engine location using a
DDT or Quicksilver Diagnostic Tool.
Flashing "nonE" – The gauge does
not see any engine computers
(ECMs). Please check wiring for bad
connections and for proper amount
of terminator resistors.
Flashing "noSt" – None of the
engine computers (ECMs) are
configured as a starboard engine.
Engines may not be compatible or
must be programmed for proper
engine location by using a DDT or
Quicksilver Diagnostic Tool.
Flashing "2001" – You will need to
manually select your engine type.
Use the
through the choices. Stnd = Stern
Drive, Inbd = Inboard, JEtd = Jet
Drive, Out2 = Outboard 2 Stroke,
Out4 = Outboard 4 Stroke.
Press
5
button to scroll
to continue.