Mercury VesselView 903 Quick Start Manual

VESSELVIEW 903
IMPORTANT: This document guides our dealers, boatbuilders, and company service personnel in the proper installation or
service of our products. If you have not been trained in the recommended servicing or installation procedures for these or
similar Mercury Marine products, have the work performed by an authorized Mercury Marine dealer technician. Improper
installation or servicing of the Mercury product could result in damage to the product or personal injury to those installing or
operating the product. Always refer to the appropriate Mercury Marine service manual for component removal and installation
instructions.
NOTE: After completing installation, place these instructions with the product for the owner's future use.

Components Contained in Kit

Qty.
1 VesselView multifunction display
1 Sealing gasket
4 Mounting screws—#4 supplied
1 Mounting screw alignment tool
1 NMEA® 2000 T‑connector
1 VesselView power harness
1 NMEA 2000 extension harness
1 Bezel
1 Sun cover
1 Template
1 Quick Start guide
1 Operation manual

Notice to Installer

IMPORTANT: The documentation must be consulted in all cases where the symbol

Safety Requirements

!
IMPORTANT: Always refer to the Operation Manual included with each engine for other important safety information.
Water depth may vary in identical locations at different times of the day or year. As operator, always monitor water depth.
Reduce speed and proceed with caution whenever you're driving a boat in shallow water or in areas where the waters are
suspected of having underwater obstacles that could be struck by the underwater drive components, or the boat bottom. Do
not use mobile devices as the sole source of navigation, or engine and vessel data.
90-8M0129930 eng MAY 2017
Description
!
© 2017 Mercury Marine
63125
, is marked.
Page 1 / 5