Table of Contents
Advertisement
Blower Cone Installation
Align the bolt holes of the Blower Cone (Item#1) to the bolt holes located on the Blower Housing of the PTO
Assembly. Secure the Blower Cone to the Blower Housing by using (3) 1/4"-20 x 3/4" HHCS (Item #4), (3) 1/4" Lock
Washers (Item #3), and (3) 1/4" Flat Washers (Item #2).
Figure A
Boot Installation
Fasten Boot Plate P#(B0906) onto top of Boot and the Boot Plate Fastener P#(B0910) on the inside of Boot
P#(V0048) using (3) P#(K1144) 5/16"-18 x 1" Carriage Bolts and (3) P#(K2516) 5/16"-18 Ny-Flange Locknuts. Align
holes with the corresponding holes marked on the top plate. Lift mower's discharge chute and place boot on mower
deck as shown. Refer to Figure B below.
Figure B
Blower Housing
Advertisement
Table of Contents
