Blower Cone Installation; Boot To Mower Deck Installation - Peco 06131512 Operator's Manual

2-17 Blower Cone Installation

Thread (1) 5/16"-18 jam nut P#(K0120) onto each end of
(2) 5/16"-18 x 2-1/2" HHCS P#(K0125) as shown in
Figure 2-17a.
Onto Each 5/16"-18 Bolt
Now partially thread (1) bolt into each of the two
threaded bosses located on the blower housing. Place
blower cone so the two tabs line up with the bolts and
tighten completely as shown in Figure 2-17b.
Figure 2-17b
Threaded
Boss
Once the (2) bolts are tight, tighten the jam nuts against
the threaded boss as shown in Figure 2-17c.
Figure 2-17c
(2nd) Tighten
Jam Nut
Refer to Figure 2-17d for proper blower cone installation
reference.
Figure 2-17d
Blower
Cone
Figure 2-17a
Thread (1) Jam Nut
Blower
Cone Tab
(1st) Tighten
Bolt

2-18 Boot To Mower Deck Installation

Secure the boot plate P#(B0001) to the aluminum boot
P#(E1103) using (2) 3/8"-16 x 1" carriage bolts
P#(K1182) and (2) 3/8"-16 nylon flange locknuts
P#(K2038). Insert the bolts from the inside so that the
threads are on top of the boot. This will prevent grass
clippings from collecting on the bolt threads. Leave the
hardware loose until the boot assembly has been
attached to the mower deck. Lift the grass deflector and
slide the boot plate under the grass deflector rod. Close
any gaps between the boot and the mower deck by
adjusting the position on the boot in the boot plate slots.
Tighten all hardware at this time. Refer to Figure 2-18a.
Figure 2-18a
Boot
Plate
Secure the boot plate P#(B1815) to the aluminum boot
P#(E1126) using (2) 3/8"-16 x 1" carriage bolts
P#(K1182) and (2) 3/8"-16 nylon flange locknuts
P#(K2038). Insert the bolts from the inside so that the
threads are on top of the boot. This will prevent grass
clippings from collecting on the bolt threads. Leave the
hardware loose until the boot assembly has been
attached to the mower deck. Lift the grass deflector and
slide the boot plate under the grass deflector rod. Close
any gaps between the boot and the mower deck by
adjusting the position on the boot in the boot plate slots.
Tighten all hardware at this time. Refer to Figure 2-18b.
Figure 2-18b
Boot
Plate
15
54" Deck
(2) 3/8"-16 x 1"
Carriage Bolts
(2) 3/8"-16 Locknuts
60" Deck
Aluminum
Boot
(2) 3/8"-16 x 1"
Carriage Bolts
(2) 3/8"-16 Locknuts