Table of Contents
Advertisement
PTO Assembly Installation
Remove (3) 1/4"-20 x 1/2" HHSTS P#(K0353) from the
PTO assembly to remove the belt guard. Insert the
mount rod of the PTO assembly, into the mounting slots
on the PTO mount plates, as shown in Figure A.
Figure A
PTO
Assembly
Mounting
Slots
PTO Assy.
Mount Rod
Remove
Belt Guard
Belt Installation/Removal &
Adjustment
Installation/Removal: Loosen the (4) 5/16"-18 x 3/4"
HHCS P#(K1153) that secure the gear box base plate.
Loosen the adjustment bolt (1) 3/8"-16 x 2" hex bolt
P#(K0348). Slide the gearbox towards the mower until
there is enough clearance for the kevlar belt to slide over
both the engine and gearbox pulleys. Install the kevlar
belt. Pivot PTO assembly to align holes, then fasten by
inserting (1) PTO mount pin P#(B0274). Secure the
mount pin using (1) hair pin clip P#(K0086). Refer to
Figures B,C & D.
Adjustment: To adjust the belt tension, turn the
adjustment bolt clockwise until there is 1" of deflection,
with 10-11lbs of pressure applied to the center of the
belt. When proper tension is achieved, tighten the (4)
5/16"-18 x 3/4" HHCS that secure the gear box base
plate to the PTO assembly. Replace the belt guard and
(3) 1/4"-20 x 1/2" HHSTS. Refer to Figure E.
14
Figure B
Gear Box
Base Plate
Figure C
Loosen
Bolt
Slide Gearbox Base
Plate Toward Engine
Figure D
Wrap Belt Around
Both Pulleys
Figure E
PTO Mount Pin
Secured w/
Hair Pin Clip
Loosen
Bolts
Loosen
Bolt
Loosen
Adjustment
Bolt
Adjustment
Bolt
Replace
Belt Guard
Advertisement
Table of Contents
