Impeller Blade Removal/Replacement - Peco 28120903 Operator's Manual

Impeller Blade Removal/Replacement

Removal
Step 1: Remove the blower cone from the blower housing
located on the PTO assembly. With the blower cone
removed, you will have access to the impeller blade
assembly. Refer to Figure A.
Step 2: Remove the 5/16"-24 LH x 1-1/4" hex bolt
P#(K1171) and washer P#(K1446).
Step 3: Insert the 1/2"-13 x 1" hex bolt (K1231) into the threads on the blade assembly and tighten. The blade
should break free from the shaft.
Step 4: Remove the blade assembly and key from the PTO shaft.
Note: If necessary, use a break free agent to aid in the removal of the blade.
Installation
Step 1: Insert the key into the key way on the PTO shaft.
Step 2: Insert the blade assembly onto the PTO shaft.
Step 3: Secure the blade assembly to the PTO shaft with (1) washer P#(K1446) and (1) 5/16"-24 LH x 1-1/4" hex bolt.
Torque the bolt to 19 ft./lbs.
Impeller Blade
Assembly P#(A1839)
Washer
P#(K1446)
5/16"-24 LH x 1-1/4"
Hex Bolt P#(K1171)
Before REMOVING/REPLACING the Impeller
Blades, be sure the Mower is TURNED OFF,
the PTO Assembly is DISENGAGED and
The Negative Cable is REMOVED from the
BATTERY. Failure to do so MAY RESULT
Key
P#(J0254)
! WARNING
in SEVERE INJURY or DEATH.
Blower Housing
P#(V0016)
PTO Shaft