Table of Contents
Advertisement
3. Acquire adequate access to the bottom of the mower
deck by raising the mower deck to the "carry" position.
4.Install the front baffle assembly using the existing 2-
M8 x 16 square neck bolts with 2 - M8 flange nuts. Fully
tighten both fasteners.
Safety Interlock Installation
Your PECO bagging system is equipped with a Safety
Interlocking system designed to disengage the blower if
the operator is not seated. The components to install
the Safety Interlock are located in Hardware Bag
P#(HB0649).
PTO Housing
16
First, install Switch Mount Bracket P#(B0839) on the
side of the PTO housing with Snap Mount Switch
P#(P0265) inserted into slot using (2) 1/4"-20 x 5/8"
Carriage Bolts P#(K1010) and (2) 1/4"-20 Ny-Flange
locknuts P#(K2014). Next, insert Rubber Grommet
P#(V0050) into hole located on the Right Mount Frame
Plate.
Feed the Safety Interlock Harness P#(P0268) end with
one connector through the grommet from the mower
outward towards the PTO. Connect to switch. Next,
carefully feed the harness around to the right side lap
bar following the fuel line and through the rubber
grommet used by the fuel line. Secure using the zip ties
provided. Once through the fuel line grommet, feed the
harness downward and to the right. Bring harness over
the frame to avoid sagging.
Locate the safety switch that engages when the lap bar
is in its outermost, neutral position. Unplug the connector
from the bottom of the switch and plug the matching
connector from the Harness to the switch. Then plug the
Lap Bar
two remaining ends together. Refer to the next page for
further reference.
Safety Switch
Switch Mount
Snap Mount
Bracket
P#(B0839)
P#(P0265)
Switch
Grommet
P#(V0050)
Advertisement
Table of Contents
