Table of Contents
Advertisement
Length Of Hose Adjustment
The hoses in steps must be cut to fit your machine. Do
not cut the hoses until you have tried to fit them on your
machine. Remember that the hoses have to be long
enough to adjust for the blower assembly's movement
as well as allow for enough clamping surface between
the inlet, blower assembly, and the deck boot.
Upper Hose Installation
Fasten the inlet to the plastic top by sliding the inlet from
the inside of the top to the outside and lock into place.
Slide a pre-assembled hose clamp onto both
ends of the 6" upper hose (Figure A). Then slide one
end of the 6" hose onto the inlet. Make sure there is
about a two-inch overlap between the hose end and the
container inlet. Proceed to slide the opposite end of the
6" hose onto the outlet of the blower assembly. See
(Figure A) for details. Make sure both ends of the
hose are clearly attached to the inlet and the blower
assembly inlet. Tighten the hose clamps.
Figure A
Inlet
22
Plastic
Top
Upper
Hose
Blower
Outlet
Lower Hose To Blower Cone
Installation
Slide a pre-assembled hose clamp over both ends of the
lower hose. Then proceed to slide the lower hose onto
the blower cone. Tighten the hose clamp. The assembly
should look like Figure A.
Lower Hose To Boot Installation
Take the unattached end of the lower hose and slide it
over the circular end of the boot. Use the lower hose
clamp to secure the hose to the boot (Figure A). Tip:
Before securing clamp rotate hose counter-clockwise
(away from yourself) approximately 1" to aid in retaining
boot to mower deck.
Hose
Clamp
Hose
Clamp
Lower
Blower
Hose
Cone
Boot
Advertisement
Table of Contents
