Cleaning Schedule (To Be Performed By Store Personnel) - Structural Concepts BLEND NM4855DSSV User Manual

CLEANING SCHEDULE (TO BE PERFORMED BY STORE PERSONNEL)

FREQUENCY
Daily Glass Surfaces: Clean side glass and shelves with household or commercial glass
cleaner.
Daily Exterior Glass: Clean with household or commercial glass cleaner.
Daily Acrylic Tray/Shelf (on NM4855DSSV Only): Use non-abrasive cloth with warm water
and mild soap solution to wipe off all surfaces. Dry with non-abrasive cloth.
Daily End Panels, Front Panel, Toe-Kick, Tray/Shelving, etc.: Wipe off all surfaces with
warm water and mild soap solution and non-abrasive cloth.
Daily Decks: Wipe off decks with moist cloth dipped in mild soap and water solution.
Daily Stainless Steel Surfaces:
• Wash with a solution of hand dishwashing liquid detergent and water, or a solution of
baking soda and water. Rinse and polish dry with paper towel or soft cloth.
• Never use scouring powders or steel wool as they will scratch stainless steel.
• Brighten by polishing with a cloth dipped in vinegar or in ammonia; sprinkle baking
soda on sponge and rub gently; rinse. Polish dry with paper towel.
• Remove streaks or heat stains from stainless steel by rubbing with club soda.
Quarterly Under Case Cleaning:
A. Rolling Case To New Location:
• If case is NOT hard wired, it may be rolled forward or backward to allow access to
case underside (depending upon its store placement).
• Use vacuum with brush extension or broom and dust pan to remove all dust, dirt,
food particles or residue.
• Roll case back into its previous location after cleaning is complete.
B. Case Component Removal/Replacement:
• Whether case is hard wired or not, case components may be removed to allow
cleaning under case.
• Front and side toe-kicks are held in place with magnets and are removable without
tools.
• Replace components when cleaning process is complete.
INSTRUCTIONS
14