SERVICE WORK ON THE CHASSIS
Installing the lower triple clamp
10.13
3
0 0 3
2
0 0 2
1
0 0 1
–
Remove O-ring
–
Take out the lower triple clamp with the steering stem.
–
Take out the upper steering head bearing.
101336-10
(XCF‑W, EXC‑F EU, EXC‑F AUS)
x
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
–
Check whether the top steering head seal
–
Slide on protective ring
101330-10
–
Position the upper triple clamp with the steering.
–
Mount screw
–
Position the clutch line, wiring harness, and voltage regulator. Mount and tighten
screws
.
Guideline
Remaining screws, chassis
101427-10
–
Position the fork legs.
Info
The topmost milled groove in the fork leg must be flush with the top edge of
the upper triple clamp.
Position bleeder screws
101332-10
–
Tighten screws
Guideline
Screw, bottom triple clamp
101333-10
. Remove protective ring
p. 109)
and O-ring
.
but do not tighten yet.
toward the front.
.
.
is correctly positioned.
M6
10 Nm (7.4 lbf ft)
M8
15 Nm
(11.1 lbf ft)
46