Mounting The Seat; Removing The Air Filter Box Lid; Installing The Air Filter Box Lid; Removing The Air Filter - KTM 250 EXC-F SIX DAYS EU Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.24

Mounting the seat

12.25

Removing the air filter box lid

12.26

Installing the air filter box lid

12.27

Removing the air filter

Note
Engine failure Unfiltered intake air has a negative effect on the service life of the engine.
–
Never ride the vehicle without an air filter since dust and dirt can get into the engine and result in increased wear.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
–
Hook in the front of the seat at the collar sleeve of the fuel tank, lower it at the rear
and simultaneously push it forward.
–
Make sure that the seat is correctly locked in.
–
Mount and tighten the screw of the seat fixing.
Guideline
Remaining screws, chassis
B01526-01
–
Pull off the air filter box lid in area
B01527-10
–
Insert the air filter box lid into the rear area
B01527-11
x
Preparatory work
–
Remove the air filter box lid. (
Main work
–
Detach air filter holder
filter with the air filter support.
–
Remove the air filter from the air filter support.
B01426-10
M6
to the side and remove to the front.
A
and clip it into the front area
A
p. 68)
at the bottom and swing it to one side. Remove the air
1
68
10 Nm (7.4 lbf ft)
.
B