Troubleshooting Cloning Mode - Motorola CLP446e User Manual

Figure 13: Cloning the Radio through a Multi-Unit Charger
5.4

Troubleshooting Cloning Mode

When and where to use:
The radio audible voice announces "Bonk" indicating that the cloning process has failed. In the event
that cloning fails, perform each of the following steps before attempting to start cloning process again.
Procedure:
1 Ensure that the batteries on both radios are fully charged and engaged properly on the radio.
2 Check the cloning cable connection on both Single-Unit Chargers (SUC).
3 Check the cloning cable connection on both Single-Unit Chargers (SUC and if the cable is
switched to "Cloning".
4 Ensure that there is no debris in the charging tray or on the radio contacts and the radio contact
is touching the SUC or MUC contact firmly.
5 Ensure that the Target Radio is turned on.
6 Ensure that the Source Radio is in cloning mode.
7 Ensure that the two radios are both from the same frequency band, same region and have the
same transmission power.
NOTE: This cloning cable is designed to operate only with compatible Motorola Solutions
SUC.
When ordering cloning cable kit, refer to part number HKKN4028_ For more information about
the accessories, see Accessories on page 47
Accessories
For more information about the accessories, see
MN006181A01-AC
Chapter 5 : Radio Cloning
35