Sending Call Tones; Muting The Radio; Escalate Call - Motorola CLP446e User Manual

MN006181A01-AC
Chapter 2 : Getting Started
Dynamic Talkaround Scan is enabled on a repeater channel through the Customer Programming
Software (CPS). The feature gives the radio the ability to scan the transmit and receive frequencies of
a repeater channel.
NOTE: The feature is given higher priority than the scan mode. If the Dynamic Talkaround
Scan and Scan are enabled on the home channel, then the radio can only support the Dynamic
Talkaround Scan. This feature is only available in CLPe PLUS model.
2.12

Sending Call Tones

Procedure:
1 To navigate to Call Tone, press the Menu button.
2 To transmit a selected call tone, press + or -.
NOTE:
Six call tones are available.
This feature is enabled through Customer Programming Software (CPS).
2.13

Muting the Radio

The mute function cuts off the speaker on your radio.
Procedure:
1 To lower or mute the volume, press and hold + or - button.
You hear a "Mute" voice prompt from the radio.
2 To unmute the volume, press any button.
You hear an "Unmute" voice prompt from the radio.
2.14

Escalate Call

Escalate Call feature allows you to switch to Escalate Call Channel and send a call tone on the
Escalate Call Channel.
To enable the Escalate Call feature, Escalate Call Channel must be configured in Customer
Programming Software (CPS). Long press menu button activates the Escalate Call feature and
automatically send as Escalate Call Tone on the Escalate Call Channel. The Escalate Call Hangtime
starts after every call ends. The radio stays in Escalate Call Hangtime for a predefined period. Escalate
Call ends when the hangtime expires and the radio returns to the previous channel. The hangtime is
configured through CPS.
Pressing the PTT button during Escalate Call Hangtime allows you to talk on the channel. Escalate
Call Hangtime restarts after the voice call is ended and you can receive calls from other radios on the
Escalate Call Channel.
Your radio follows the selected channel behavior except the call tone and no channel announcement
upon switching to Escalate Call Channel. The call tone is configured through CPS by selecting one of
the six call tones.
To exit Escalate Call Channel before hangtime expires, short press either On, Off, Menu button, or
long press Menu button.
22