Motorola CLP446e User Manual page 38

MN006181A01-AC
Chapter 7 : Troubleshooting
If...
Message not transmitted or received
Heavy static or interference
Low batteries
Drop-in Charger LED light does not blink
Battery does not charge although it has
been placed in the drop-in charger for a
while
38
Then...
age in industrial and commercial build-
ings. Increasing power provides greater
signal range and increased penetration
through obstructions.
Perform one of the following actions:
• Ensure the PTT button is completely
pressed when transmitting.
• Confirm that the radios have the
same Channel, Frequency, Interfer-
ence Eliminator Code, and Scramble
Code settings. See Transmitting and Re-
ceiving on page 16.
• Recharge, replace, or reposition batter-
ies. See Battery Specifications on page
23.
• Change the radio placement. Obstruc-
tions and operating indoors, or in vehi-
cles, may interfere. .
• Verify that the radio is not in Scan mode.
See Scanning Radio Channels on page
21.
Radios are too close. Ensure the transmit-
ting and receiving radios are at least 5 ft (1.5
m) apart.
Radios are too far apart or obstacles are
interfering with transmission.
Recharge or replace Li-Ion battery.
NOTE: Extreme operating temper-
atures affect battery life.
See Battery Specifications on page
Perform one of the following actions:
• Verify that the radio and battery is prop-
erly inserted.
• Check the battery and charger contacts
to ensure that they are clean and charg-
ing pin is inserted correctly.
See Charging a Stand-Alone Battery with
the Drop-in Tray SUC on page 25
Charger LED Indications on page
Perform one of the following actions:
• Verify the drop-in tray charger is prop-
erly connected and corresponds to a
compatible power supply. See
23.
and
27.
Charging