Terex GS32MT-101 Operator's Manual page 51

First Edition • Third Printing
Lift Tools Pipe Cradle Operation
1 Place the load so that it rests in both Lift Tools
Pipe Cradles. The length of the load should be
parallel with the length of the platform and
centered between the Lift Tools Pipe Cradles.
2 Secure the load to each Lift Tools Pipe Cradle.
Pass the nylon strap over the load. Depress
the buckle and slide the strap through. Tighten
the strap.
3 Gently push and pull on the load to make sure
the Lift Tools Pipe Cradles and load are
secure.
4 Keep the load secured when the machine is
moving.
The Lift Tools Pipe Cradles assembly weighs
assembly weighs 25 lbs/11.4 kg.
Maximum Lift Tools Pipe Cradles Capacity
GS-1432m, GS-1932m, GS-1932m Lite
Tip-over hazard. The weight of the Lift Tools
Pipe Cradle assembly and the load in the Lift
Tools Pipe Cradle assembly will reduce the
rated platform capacity of the machine and
must be factored into the total platform load.
Tip-over hazard. The weight of the Lift Tools
Pipe Cradle assembly and the load in the Lift
Tools Pipe Cradle may limit the maximum
number of occupants in the platform.
Large pipe cradle capacity: 6" Maximum diameter.
See load chart for weight capacity.
Do not operate unless you are adequately
instructed and are aware of all hazards associated
with lifting pipes.
Do not cause a horizontal force or side load to the
machine by raising or lowering a fixed or
overhanging load.
Do not transport the unit with Lift Tools Pipe
Cradles installed. Remove entire assembly before
transporting the unit.
Part No. 1308591GT
215 lbs
97.5 kg
GS -1432m • GS -1932m • GS
™ ™
Operating Instructions
Panel Carrier Instructions
The Lift Tools Panel Carrier assembly consists of
a carrier assembly and a strap assembly.
1 carrier
2 carriage bolt, 1/4-20 x 0.75"
3 nut, 1/4-20
4 bolt, 3/8-16 x 2.25"
5 strap
6 bolt, 1/4-20 x 0.75"
7 nut, 3/8-16
8 anchor, strap
9 decal, warning
-1932m Lite
™
Operator's Manual
49