Terex GS32MT-101 Operator's Manual page 35

First Edition • Third Printing
Test Drive Tilt Cutout
Note: Perform this test from the ground with the
platform controller. Do not stand in the platform.
45 Fully lower the platform.
46 Drive the machine onto a slope where the
chassis angle is greater than 1.5° side to side.
47 Raise the platform to approximately
9 ft/2.74 m.
Result: The platform should stop and the tilt
alarm will sound at 180 beeps per minute. The
platform controls LED readout should display
LL and the ground controls LCD should
display LL: Machine Tilted.
48 Press the drive function button.
49 Press and hold the function enable switch on
the control handle.
50 Move the control handle in the direction
indicated by the blue arrow, then move the
control handle in the direction indicated by the
yellow arrow.
Result: The drive function should not work in
either direction.
51 Fully lower the platform.
52 Drive the machine.
Result: The machine should drive.
53 Return to level ground and raise the platform
in excess of approximately 9 ft/2.74 m.
Part No. 1308591GT GS -1432m • GS -1932m • GS
™ ™
54 Drive the machine onto a slope where the
pitch angle is greater than 1.5° side to side.
Result: The machine should stop once the
machine reaches 1.5° of chassis tilt and the tilt
alarm will sound at 180 beeps per minute. The
platform controls LED readout should display
LL and the ground controls LCD should
display LL: Machine Tilted
55 Return to level ground and fully lower the
platform.
56 Drive the machine onto a slope where the
chassis angle is greater than 3° front to back.
57 Raise the platform to approximately
9 ft/2.74 m.
Result: The platform should stop and the tilt
alarm will sound at 180 beeps per minute. The
platform controls LED readout should display
LL and the ground controls LCD should
display LL: Machine Tilted.
58 Press the drive function button.
59 Press and hold the drive/steer function enable
switch on the control handle.
60 Move the control handle in the direction
indicated by the blue arrow, then move the
control handle in the direction indicated by the
yellow arrow.
Result: The drive function should not work in
either direction.
-1932m Lite
™
Operator's Manual
Inspections
33