Cleaning The Body And Control Panel; Cleaning The Water Intake Filters; Draining Remaining Water And Cleaning The Pump Filter - Beko WRE 7512 XWW User Manual

5.2 Cleaning the loading door and the drum
Residues of softener, detergent and dirt may accumulate in your machine in time and may cause
unpleasant odours and washing complaints. To avoid this, use the Drum Cleaning programme. If your
machine is not featured with Drum Cleaning programme, use Cottons-90 programme and select
Additional Water or Extra Rinse auxiliary functions as well. Run the programme without any laundry in
the machine. Before starting the programme, put max. 100 g of powder detergents into the main wash
detergent compartment(compartment nr. 2). If the detergent is in tablet form, put only one tablet into
compartment nr. 2. Dry the inside of the bellow with a clean piece of cloth after the programme has
come to an end.
C
Repeat Drum Cleaning process in every 2 months.
Use an detergents suitable for the washing machines.
C
Foreign metal substances will cause rust stains in the drum. Clean the stains on the drum surface by using
cleaning agents for stainless steel. Never use steel wool or wire wool.
A
WARNING:
Never use sponge or scrub materials. These will damage the painted and plastic surfaces.

5.3 Cleaning the body and control panel

Wipe the body of the machine with soapy water or non-corrosive mild gel detergents as necessary, and
dry with a soft cloth.
Use only a soft and damp cloth to clean the control panel.

5.4 Cleaning the water intake filters

There is a filter at the end of each water intake valve at the rear of the machine and also at the end of
each water intake hose where they are connected to the tap. These filters prevent foreign substances
and dirt in the water to enter the washing machine. Filters should be cleaned as they do get dirty.

5.5 Draining remaining water and cleaning the pump filter

The filter system in your machine prevents solid items such as buttons, coins and fabric fibers clogging
the pump impeller during discharge of washing water. Thus, the water will be discharged without any
problem and the service life of the pump will extend.
If the machine fails to drain water, the pump filter is clogged. Filter must be cleaned whenever it is
clogged or in every 3 months. Water must be drained off first to clean the pump filter.
In addition, prior to transporting the machine (e.g., when moving to another house) and in case of
freezing of the water, water may have to be drained completely.
A
WARNING:
If the product is not in use, turn the tap off, detach the supply hose and drain the water inside
the machine against any freezing possibility in the region of installation.
WARNING:
After each use close the supply hose tap of the product.
42 / EN
After every washing check that no foreign substance is left in the drum.
If the holes on the bellow shown in the figure is blocked, open the holes
using a toothpick.
1 Close the taps.
2 Remove the nuts of the water intake hoses to access
the filters on the water intake valves. Clean them with
an appropriate brush. If the filters are too dirty, take
them out by means of pliers and clean them.
3 Take out the filters on the flat ends of the water
intake hoses together with the gaskets and clean
thoroughly under running water.
4 Replace the gaskets and filters carefully in their places
and tighten the hose nuts by hand.
Washing Machine / User's Manual