Maintenance And Cleaning; Cleaning The Detergent Drawer; Cleaning The Body And Control Panel; Cleaning The Water Intake Filters - Beko WTL 11019 W User Manual

Table of Contents

Advertisement

6

Maintenance and cleaning

Service life of the product extends and frequently
faced problems decrease if cleaned at regular
intervals.

6.1 Cleaning the detergent drawer

Clean the detergent drawer at regular intervals
(every 4-5 washing cycles) as shown below
in order to prevent accumulation of powder
detergent in time.
1.Detergent drawer is closed.
2. Pulling detergent drawer to the front side.
3. Turning detergent drawer to upper side,
and taking drawer out.
Cleaning detergent drawer by water.
24 / EN
6.2 Cleaning the body
and control panel
Wipe the body of the machine with soapy water or
non-corrosive mild gel detergents as necessary,
and dry with a soft cloth.
Use only a soft and damp cloth to clean the
control panel.
6.3 Cleaning the water intake filters
There is a filter at the end of each water intake
valve at the rear of the machine and also at the
end of each water intake hose where they are
connected to the tap. These filters prevent foreign
substances and dirt in the water to enter the
washing machine. Filters should be cleaned as
they do get dirty.
1. Close the taps.
2. Remove the nuts of the water intake hoses to
access the filters on the water intake valves.
Clean them with an appropriate brush. If the
filters are too dirty, take them out by means of
pliers and clean them.
3. Take out the filters on the flat ends of the water
intake hoses together with the gaskets and
clean thoroughly under running water.
4. Replace the gaskets and filters carefully in their
places and tighten the hose nuts by hand.
Washing Machine /User's Manual

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wtl 11019 m

Table of Contents