Adjusting The Feet; Electrical Connection - Beko WRE 7512 XWW User Manual

A
WARNING:
Moreover, there is risk of scalding due to high washing temperatures! To prevent such situations and to
ensure smooth water intake and discharge of the machine, fix the end of the discharge hose tightly so that
it cannot come out.
into the dirty water or do not drive it in the drain more than 15 cm. If it is too long, cut it short.
• The end of the hose should not be bent, it should not be stepped on and the hose must not be pinched
between the drain and the machine.
• If the length of the hose is too short, use it by adding an original extension hose. Length of the hose
may not be longer than 3.2 m. To avoid water leak failures, the connection between the extension hose
and the drain hose of the product must be fitted well with an appropriate clamp as not to come off and
leak.

2.6 Adjusting the feet

1. Loosen the lock nuts on the feet by hand.
2. Adjust the feet until the product stands level and balanced.
3. Tighten all lock nuts again by hand.
A
WARNING:

2.7 Electrical connection

Connect the product to a grounded outlet protected by a 16 A fuse. Our company shall not be liable for
any damages that will arise when the product is used without grounding in accordance with the local
regulations.
• Connection must comply with national regulations.
• Power cable plug must be within easy reach after installation.
• If the current value of the fuse or breaker in the house is less than 16 Amps, have a qualified electrician
install a 16 Amp fuse.
• The voltage specified in the "Technical specifications" section must be equal to your mains voltage.
• Do not make connections via extension cables or multi-plugs.
B
WARNING:
Transportation of the product
1. Unplug the product before transporting it.
30 / EN
Your house will be flooded if the hose comes out of its housing during water discharge.
• The hose should be attached to a height of at least 40 cm,
• In case the hose is elevated after laying it on the floor level
• To prevent flowing of dirty water back into the machine and
A
WARNING:
vibration-free, it must stand level and balanced on its feet. Balance the machine by
adjusting the feet.
Otherwise, the product may move from its place and cause crushing and vibration
problems.
Do not use any tools to loosen the lock nuts. Otherwise, they will get damaged.
Damaged power cables must be replaced by the Authorized Service Agents.
and 100 cm at most.
or close to the ground (less than 40 cm above the ground),
water discharge becomes more difficult and the laundry
may come out excessively wet. Therefore, follow the heights
described in the figure.
to allow for easy discharge, do not immerse the hose end
In order to ensure that the product operates more silently and
Washing Machine / User's Manual