Factory Reset "Reset; Tutorials; Firmware Update Of Rc6Gs V3 - RadioLink RC6GS V3 Instruction Manual

Hide thumbs Also See for RC6GS V3:

Table of Contents

2.25 Factory Reset "RESET"

RESET- Data reset function: All the data for any model memory can be reset to original factory defaults. Often this

function is done to get a "fresh start" and clear the memory before inputting new model settings.

Note: Resetting the current model memory will permanently erase ALL programming information for that model. The

data cannot be recovered. Do not reset the model unless you are certain you want to clear-out that memory and start

from scratch.

Please search Radiolink_official on YouTube to access RadioLink official channel and check all the below video tutorials of RC6GS V3. View

the playlist of RC6GS V3 or search key words on our channel for the function you want.

3.2 Throttle and Steering Calibration

3.3 Connect RC6GS V3 to Simulator

3.4 THSPD Throttle Delay Function on RC6GS V3

3.5 TIMER Function on RC6GS V3

3.6 Dual Rate Function on RC6GS V3

3.7 EPA Function on RC6GS V3

3.8 Set Different ALARM for 30 Different Models on RC6GS V3

3.9 ID Seed Function on RC6GS V3

3.10 Cruise Control Function on RC6GS V3

3.11 Connect RC6GS V3 to TBS Crossfire

3.12 Head Track Setup on RC6GS V3

3.13 LK-A/LK-D Button Setup on RC6GS V3

3.14 Setup FPV Monitor on RC6GS V3

3.15 TX Low power & Power Supply Options of RC6GS V3

Technical Support Here

Contact RadioLink RL

via Facebook Messenger

If the above communication cannot solve your problem, you can also send emails to our technical support:

This content is subject to change. Download the latest version from https://www.radiolink.com/rc6gsv3_manual

III. Tutorials

RC6GS V3 User Manual

Thank you again for choosing RadioLink product.

RC6GS V3 Tutorials

after_service@radiolink.com.cn

Table of Contents