Table of Contents
Advertisement
7.2 Message List
"Message" dialogue box consists from "Title" , "Message" and "Command button" as shown in Pic. 30.
Following is message list appears while this program is run.
1) "Caution" message list
Name of
Message
dialogue
Input
Value is not correct.
confirmation
[###] module is missing.
(### : Name of module)
Settings of measurement
interval is 0.1～6553.5 sec.
MAX of measurement time
is XXXsec.
Setting
There is no set probe.
confirmation
RS232C
RS232C can not be opened.
Error
Error occurred when close
Message
RS232C.
RS232C receive time-out.
There are omissions in
take in data.
Data error occurred.
Numbers
ANEMOMASTER
connected
corresponds to set value.
Data buffer over occurred.
ANEMOMASTER
memory over occurred.
RS232C
error occurred.
Print
out
Printer error.
error
message
Command button : 3 [ ok ]
Title
Check input value
Input module type
Set
measurement
parameter
Multi-channel
ANEMOMASTER
Soft ware
Multi-channel air
Velocity meter
Soft ware
of
is
not
Correspondence
Multi-channel
ANEMOMASTER
soft ware
26
Command
Cause
button
3
Input value is out of set range or
letters were input.
Input name of module is not
correct.
Input parameter is not correct.
3
Confirmation will appear when
probe was not set before data
take in starts.
3
Settings of RS232C is not
correct.
RS232C setting is not correct.
Timer of ANEMOMASTER : 5sec
Timer when data take in :10sec
Followings happened .
1) Take in data delimiter does
not corresponds to settings.
2) Sampling repetition time does
not corresponds to settings.
Other data error occurred.
Numbers of ANEMOMASTER
connected does not corresponds
to settings.
Data
buffer
correspondence of PC occurred.
Memory over of main body of
ANEMOMASTER occurred.
Other
correspondence
occurred.
3
Printer error will occur while
printing
if
printer
connected or does not correspond
to Windows 95.
over
for
error
is
not
Advertisement
Table of Contents
