Water Conditions - Maytronics ACTIVE 6 User Instructions

The unit must be connected only to a supply circuit that is protected by a ground-fault circuit
interrupter (GFCI). This GFCI should be tested on a routine basis. To test the GFCI, push the test
button. The GFCI should interrupt power. Push the reset button. Power should be restored. If
the GFCI fails to operate in this manner, the GFCI is defective. If the GFCI interrupts power to the
WARNING
power unit without the test button being pushed, a ground current may be flowing, indicating
the possibility of an electric shock. Do not use the power unit. Disconnect the power unit and
contact the manufacturer for assistance.
To reduce the risk of electric shock replace damaged cord immedietely.
Do not use extension cord to connect unit to electric supply; provide a properly located outlet.
WARNING
Please ensure that the following PRECAUTIONS are implemented:
Operator should keep hands away from driving belt mechanism.
CAUTION
Position the Caddy and power supply at least 3.5m/12ft from pool's edge – during operation.
CAUTION
For continued protection against possible electric shock, the power supply unit should be placed
at least 11cm/4in above ground.
CAUTION
When lifting the Robot Pool Cleaner, take care to prevent back injury.
CAUTION
Do not bury cord – locate cord to minimize abuse from lawn mowers, hedge trimmers and other
equipment.
CAUTION
Do not use the pool cleaner if you have added liquid flocculant or any other clarifier to the pool
water. These substances obstruct and damage the robot's filters.
CAUTION

3.1 Water Conditions

Use the Robotic Pool Cleaner in the following water conditions:
Chlorine
pH
Temperature
NaCl
M600 / ZENIT 60 / ACTIVE X6 / ACTIVE ULTIMATE Robotic Pool Cleaner
Max 4 PPM
7.0-7.8 PPM
6-35°C / 43-95°F (below 15°C / 59°F climbing performance may be affected)
Maximum = 5000 PPM
User Instructions
| 3