Table of Contents
Advertisement
Read First
Operating the air purifi er via smartphone
2
If router does not have built-in WPS
Follow the steps below even if you are choosing to not use WPS.
1 Press
to activate the wireless LAN connection adaptor.
2 Launch the app and follow the guidance to connect the air purifier and router.
•
SSID and KEY are required for connection.
(A sticker with the SSID and KEY can be found in the location shown in the illustration on the
right.)
For detailed specifi cations, installation instructions, setting methods, FAQ, declaration of conformity and the latest version of this
manual, visit app.daikineurope.com.
Communication lamp status
Lights up or blinks according to the wireless LAN communication status, as shown below.
Lit up
Unlit
If the unit (air purifi er) can't be found with the app
• Perform connection settings again.
• Move the router closer to the air purifi er.
If you want to turn the wireless LAN connection adaptor function OFF
Press the
If necessary
If you want to reset the wireless LAN connection adaptor to factory default settings
• If you want to redo the settings, etc., the wireless LAN connection adaptor can be reset to the factory default settings from the
time of purchase.
If you reset to factory default settings, network settings will be erased, as well as historical data such as the number of sensor
responses.
• If disposing of the unit or transferring it to a new user, reset it to factory default settings in order to erase the internal data.
1 Press
2 Press and hold
• A short beep sounds, and the Communication lamp [orange] and the AUTO FAN MODE lamp [white] blink for about
20 seconds.
• When reset to factory default settings is completed, a long beep sounds and all lamps turn off.
• If, after step 2 , the Communication lamp lights up and only the AUTO FAN MODE lamp turns off, repeat steps 1 and 2 .
17
Green
Wireless LAN connection adaptor is connecting to router
• Wireless LAN connection adaptor and router connection not set
• Wireless LAN connection adaptor is connecting to router (immediately after turning
Orange
communication ON)
Red
Wireless LAN connection adaptor cannot connect to the Internet
Wireless LAN connection adaptor function is OFF
.
If you want to turn the adaptor function "ON", press
to turn on the Communication lamp.
and
at the same time for about 5 seconds while the unit is stopped.
FAN
MODE
Connect the Air Purifi er to the Network
Location of SSID and KEY
again.
Advertisement
Table of Contents
