Table of Contents
Advertisement
3. Refer to
Figure
12. Install the Enhanced Front End Control assembly included in this kit into
slot 6 in the chassis securing with the ejector.
4. Reattach the ribbon cables W16, W17, and W18 to the Front End Control assembly (1).
5. If the analyzer does not have Option 503, reconnect W22 wire harness to the Front End Control
assembly (1).
Figure 12
Enhanced Front End Control Assembly Installation
Installation Note N9020-90230
Option HL6, External Mixing Upgrade Kit, Serial Prefix ≥ MY/SG/US5328
21
Advertisement
Table of Contents
