Table of Contents
Advertisement
TRUE
tcgg
MAINTENANCE, CARE, CLEANING
CLEANING THE CONDENSER COIL
When using electrical appliances, basic safety precautions should be
followed, including the following:
TOOLS REQUIRED
•
Phillips Screwdriver
•
Stiff Bristle Brush
•
Adjustable Wrench
STEP 1 - Disconnect power to unit.
STEP 2 - Take off rear lower grill assembly by removing two (2)
bottom screws. If necessary, loosen screws holding the top pivot
pins. Swing grill up and remove frame hooks from pivot pins at top
of louver.
STEP 3 - Remove bolts anchoring compressor assembly to
frame
rails
and
carefully
are flexible).
STEP 4 - Clean off accumulated dirt from condensing coil with a
stiff bristle brush.
STEP 5 - Lift cardboard cover above fan at plastic plugs and carefully
clean condenser coil and fan blades.
STEP 6 - After brushing condenser coil vacuum dirt from coil, and
interior floor.
STEP 7 - Replace cardboard cover. Carefully slide compressor
assembly back into position and replace bolts.
STEP 8 - Reinstall louver assembly onto unit, tighten all screws.
STEP 9 - Connect unit to power and check to see if condensing
unit is running.
15
•
Air Tank or CO2 Tank
•
Vacuum Cleaner
slide
out
(tube
connections
.
.
www
truemfg
com
Advertisement
Table of Contents
