Table of Contents
Advertisement
SAE and DISPLAY versions
6.8.2
• Place the pot under the hot water noz-
zle.
• Press the water button
for the hot water to be dispensed.
• To stop the dispensing ahead of time,
press the hot water dispensing button
again
or press the
6.8.3
Programming the hot
water
The machine is programmed by default.
Should the hot water doses need to be
modified, proceed as follows:
• Place the pot under the hot water
nozzle.
• Press the
button for at least 5
seconds, until all the dose button LEDs
are lit.
• Press the hot water dispensing button
.
• To confirm the dose, press the
button again.
• When the programming is complete,
press the
button until all of the
LEDs on the pushbutton panel go off.
36
104
of
and wait
button.
6.9 Automatic steam wand (optional)
Tips regarding its use
6.9.1
• Only froth the amount of milk that you intend to use; once
heated, the milk will have to be completely poured out of
the jug and cannot be reheated.
• The automatic steam wand only guarantees an accuracy
of ± 3°C between the set temperature and the actual milk
temperature, if the starting milk temperature is 4°C.
• As the steam automatically stops dispensing when the set
milk temperature is reached, only fill the jug half way in
order to prevent the milk froth from spilling out.
• Use a suitably-sized jug for the amount of milk that re-
quires frothing (approx. 200 ml is recommended) and
make sure that it is circular and not conical (see the im-
age).
Dispensing
6.9.2
Do not direct the steam towards hands or other
parts of the body. Do not touch the steam nozzles
with bare hands; use the appropriate PPE.
• Immerse the automatic steam wand
nozzle into the milk.
• Select the
button.
• Wait until the dispensing process is
complete. As an indication that the
set temperature has been reached,
the
button will also
change status.
• To stop dispensing ahead of time,
press the
button again.
The temperature of the beverage will
always be shown on the display.
TECHNICIANS' manual
Advertisement
Table of Contents
