Advertisement
thickness of the branch. This prevents the branch from breaking when you cut it from the
top a little further away from the trunk. To finish, saw the stump by making a straight cut.
If you wish, you can seal the cut using a suitable product.
CARE AND MAINTENANCE
Regularly maintain your tool. This will keep your tool running smoothly and extend its life. The
tool must always be kept in good working order.
Do not use abrasive, caustic products to clean the tool. These types of products will damage
your tool.
Regular maintenance is important; Failure to maintain the tool will result in rapid wear of parts
that can cause malfunction and accidents. In addition, a poorly maintained tool will cause
poor work results and rapid aging
Wear protective gloves when servicing the tool.
The tool must be completely extinguished and cooled before any maintenance and
intervention.
Perform the machine maintenance as described in this manual. Use accessories and
replacement parts only recommended by us. Do not remove or modify system components or
modify the speed of the tool (serious accidents may result). Repairs or modifications must be
made only by a qualified service. No repairs or modifications must be done by the user.
After work, it is essential to always check the entire machine and clean it.
Regular checks and maintenance:
Check the air filter (to be cleaned if necessary)
-
Check spark plug (replace if necessary)
-
The correct operation and quantity of the cutting wire.
-
Always switch the drive unit off when performing any maintenance or repair work.
Repairs should only be carried out by authorized specialists with the necessary technical
knowledge. Interventions by non-specialists may damage the machine or be hazardous to
safety.
Follow the instructions below:
-
Ensure that all nuts, bolts and screws are tightened to ensure that the machine meets all
safety conditions
-
Never store the machine with fuel remaining in the tank in a building where gasoline
vapors may come in contact with flames or sparks.
-
Allow the engine to cool before storing it in an enclosed area.
To reduce the risk of fire, remove grease, grease and grease from the engine, muffler,
-
battery and gasoline storage area.
Replace worn or damaged components.
-
When the fuel tank is to be emptied, do so outdoors.
-
Do not attempt to repair the machine unless authorized to do so.
-
Use only spare parts and accessories recommended by the manufacturer.
-
27
Advertisement
