Advertisement
5. UTILISATION
a) Starting the 4-in-1 multifunction tool
Do not start the appropriate module of the machine until all components have been
connected correctly! Attach the cutting blade of the brush cutter with a torque of 20 Nm
and the cutting head of the mower with a tightening torque of 15Nm.
WARNING Fill the fuel tank before tightening the fuel tank cover.
Put the machine on a level, solid floor. Keep the cutting head away from the ground
-
and away from surrounding objects (Fig.5).
-
Press the priming bulb 5 to 8 times until fuel flows through the
clear hose.
-
Position the choke in the closed position.
Set the ON/OFF switch to position "I". Make sure the cutting
-
head is clear.
Keep the machine on the ground safely and then pull the starter until the engine
-
starts.
WARNING
The machine is equipped with a centrifugal clutch system.
When starting the engine, place the machine on a level, clean floor and hold it firmly to prevent the
sharp components or the throttle lever from coming into contact with any objects when the engine is
started.
IMPORTANT
Avoid pulling the starter to the end or return the cable by suddenly releasing its handle. This can cause
the engine to fail.
Position the choke in the "open" position and restart the engine.
Let the engine warm up a few minutes before starting work.
NOTE
When restarting the engine directly after stopping it, keep the choke switch in the
"open" position.
Overheating complicates engine starting due to overfilling of fuel. If the engine does
not start after several attempts, open the starter and press the starter several times,
or remove and dry the spark plug.
b. Stop the engine
Release the throttle lever and let the engine run for about 30 seconds.
Set the ON/OFF switch to the 0 position.
IMPORTANT
Except in case of emergency, do not switch off the engine by pulling on the choke lever.
If the engine does not stop by pressing the stop switch, move the choke to the closed position.
24
Advertisement
