Advertisement
Use the shoulder harness at all times adjust both harness and harness clamp on the
-
unit so that the unit hangs a few inches above ground level .The cutting head and
the debris shield should be level in all directions. Harness the unit on the right side of
your body.
Cut only with the side of the blade that the debris is moving away from you.
-
If kickback occurs, the blade may be dull, or the material so thick and hard that you
-
should use other tool instead of this machine.
Do not force the blade to cut. Do not change the angle of cut after into the wood.
-
Avoid using any pressure or leverage which could cause the blade to bind or crack.
Scything weeds
This is cutting by swinging the blade in a level arc. It can quickly clear areas of field grass
and weeds. Scything should not be used to cut large, tough weeds or woody growths.
Scything can be done in both directions, or just in one way which results in the debris
being thrown away from you.
That is using the side of the blade that it is rotating away from you. Tilt down the blade
slightly on this same side. You will be hit by some debris if you scythe in both directions.
e.
Using the hedge trimmer
When using the machine on lawns, hold the scythe at an angle of 30 ° and perform semicircular
movements by sweeping the ground from left to right.
The best results are obtained when the grass is 15 cm high. When the grass is higher, we
recommend repeating the mowing several times.
Warning! Never place the cutting head on the ground while the machine is running.
-
It is recommended to cut the trapezoidal hedges to prevent the lower branches from being
stripped. This corresponds to the natural growth of plants and hedges can be potentially
prosperous. The cut makes the new annual shoots reduced, so a dense branching and a good
protection of the sight must be considered.
First cut the edges of a hedge. Move the hedge trimmer to cut the part that grows greatly from
-
bottom to top. If you cut from top to bottom, the thinner branches move outward; Narrow
places or holes may form.
Cut the top of the hedge, just like a roof or a round shape.
-
-
Cut the seedlings into the desired shape. The main stem must be intact and remain until the
hedge reaches the proposed elevation. All other shoots should be cut to half.
f.
Using the pole pruner
Never use the tool at an angle of more than 60 °. The correct operation of the pruner is
not impaired at angles greater than 60 °,
but the risk of injury increases due to
sudden drops of branches. Pay attention
to the floor in front of you when using the
appliance. This allows you to avoid
tripping over branches on the ground.
Never use the saw without oil. Use a
biodegradable chain oil. The pruning
machine uses a low rebound chain. In
addition, special attention has been paid
to the construction of the device to
prevent the smallest possible rebounds
given the technical conditions given.
Nevertheless, a slight rebound can not be
ruled out by using the upper cutting blade.
Expect a rebound when using this side of the blade or when the top of the blade comes
into contact with another branch. The device should always be used with both hands. The
thin branches can be cut at once. To prevent a branch from splitting or bending, it is
advisable
to slice it end to end. When slitting longer branches, the branch should be cut
from the bottom. First cut the branch from below at a point away from where you want to
saw the branch. The notch must have a depth between one third and one half the
60°max.
26
Advertisement
