Table of Contents
Advertisement
4.5 JAMMING AND BREAKDOWNS
- When the drill gets stuck, release the accelerator to slow down the machine. you have to release the
accelerator and turn it back to idle to loosen it.
- In case of failure, stop the machine completely. Check the machine and have it inspected and
repaired by a qualified service technician.
5. MAINTENANCE AND STORAGE
5.1 MAINTENANCE
Service your tool regularly. This shall keep your tool in good working condition and extend its service life.
Do not use abrasive and corrosive agents to clean the tool. These types of products damage your
tool.
Do not repair it yourself. Repairs and inspections should be performed by a qualified person or an
authorized service centre (please contact your dealer).
After each use
Check the rod and tool body (cleanliness, wear, damage, etc.). If you notice damage, wear or malfunction,
do not use the tool and submit it to a qualified service for inspection and repair.
Maintenance schedule
The maintenance work described below may be performed by the operator. You can also request a
qualified technician to perform this maintenance work.
Checking the
Engine oil
oil level
Change
Checking
Air filter
Cleaning-
change
Cleaning
readjusting
Spark plug
Change
5.2 STORAGE
Cleaning the machine
-
- Store the machine in a dry and safe place. It should be out of the reach of children. Place the machine in
its packaging to avoid contact with the drill rod.
- When storing for long periods of time, empty the fuel tank completely.
After
1
month or
st
each use
20 hours
√
√
or
Everyseason
or 50 hours
√
√
11
6 months or
12 months or
100 hours
300 hours
√
√
√
Advertisement
Table of Contents
