Download Print this page

Troubleshooting - Kogan KAM12PDWFSA Instructions Manual

12 place dishwasher

Advertisement

TROUBLESHOOTING

Before calling for service, refer to the troubleshooting steps on the following pages. If you
are still unable to resolve the issue, contact help.Kogan.com for support.
Problem
Dishwasher
doesn't start
Water not
pumped form
dishwasher
Suds in the tub
36
Possible Causes
Fuse blown or the circuit
breaker tripped
Power supply is not
turned on
Water pressure is low
Door of dishwasher not
properly closed
Twisted or trapped drain
hose
Filter clogged
Kitchen sink clogged
Wrong detergent
Spilled rinse-aid
What To Do
Replace fuse or reset circuit breaker.
Remove any other appliances sharing
the same circuit with the dishwasher.
Ensure the dishwasher is turned on and
the door is closed securely. Make sure
the power cord is properly plugged into
the wall socket.
Check that the water supply is
connected properly and the water is
turned on.
Make sure to close the door properly
and latch it.
Check the drain hose.
Check the filter.
Check the kitchen sink to make sure it is
draining well. If the problem is the
kitchen sink that is not draining, you
may need a plumber rather than a
serviceman for dishwasher.
Use only the special dishwasher
detergent to avoid suds. If this occurs,
open the dishwasher and let suds
evaporate. Add 1 litre of cold water to
the bottom of the dishwasher. Close
the dishwasher door, then select any
cycle. Initially, the dishwasher will drain
out the water. Open the door after
draining stage is complete and check if
the suds have disappeared. Repeat if
necessary
Always wipe up rinse-aid spills
immediately

Advertisement

loading