Advertisement
Step 3: Tension adjustment of the door spring
1.
The door springs are set from the factory to the proper tension for the outer door. If
wooden panels are installed, you will have to adjust the door spring tension. Rotate
the adjusting screw to drive the adjustor to strain or relax the steel cable.
2.
Door spring tension is correct when the door remains horizontal in the fully opened
position yet rises to a close with the slight lift of a finger.
Step 4: Dishwasher installation steps
1.
Attach the condensation strip under the work surface of cabinet. Please ensure the
condensation strip is flush with edge of work surface.
2.
Connect the inlet hose to the cold-water supply.
3.
Connect the drain hose.
4.
Connect the power cord.
5.
Place the dishwasher into position.
6.
Level the dishwasher. The rear foot can be adjusted from the front of the
dishwasher by turning the Philips screw in the middle of the base of the dishwasher.
To adjust the front feet, use a flat blade screwdriver and turn the front feet until the
dishwasher is level.
7.
Install the wooden panel to the outer door of the dishwasher.
8.
Adjust the tension of the door springs by using an Allen key turning in a clockwise
motion to tighten the left and right door springs. Note: Failure to do this could
cause damage to your dishwasher.
9.
The dishwasher must be secured in place. There are two ways to do this:
A. Wooden benchtop: Place the installation hook into the slot in the side panel
and secure it to the work surface using wood screws.
B.
Marble or granite benchtop: Fix the side using screws.
16
Advertisement
