Siemens ARDOCELL PA 4 Series Operating Manual page 51

s
General Functions (configuration layer:
Parameter Function
LED.G
Green status LED
PILO.
Activate laser*
PIL.T
Laser ON-time*
TERM.
Assign Interface
Automatic tempera-
A.STR.
ture data output
Cycle for automatic
A.CYC.
temp. data output
ADDR.
Device address
DISP.
Display panel
UNIT
temperature scale
Screen insert tem-
C.OVL.
perature reading**
TBC exposure me-
C.TBC.
tering**
C.COL.
White balance**
SAVE
Save
ESC
Escape
* only available for models with laser sighting
** only available with ATD function
*** only available with camera
Displayed temperature readings (Configuration layer:
Parameter Function
two-colour/ratio
Q.
temp. reading
Temp. reading
L1.
Lambda1
L2.
Temp. reading
Operating manual PA
C011
)
Explanation
ON LED indicates 24V
DO1 LED indicates digital output 1
DO2 LED indicates digital output 2
TAC1 LED indicates running measurement in
ATD function L1**
TAC2 LED indicates running measurement in
ATD function L2**
LED indicates running measurement in
TACQ
ATD function Quotient**
INT keypress
OFF laser disabled
T.DI1 edge-triggered, switching input 1
T.DI2 edge-triggered, switching input 2
1-15: select auto laser shut-off in minutes
OFF non-terminal mode
USB terminal mode at USB interface
R485 Terminal mode at RS485 (Halbduplex)
OFF automatic temp. data output is off.
ON temp. data output at PC terminal
Select cycle time in s
Enter address of device for non-terminal mode
the display panel indicates "on"
"ON"
indicate temperature of source Ao1
IA1
degrees Celsius
°(
°F degrees Fahrenheit
"ON"
"OFF"
spot weighted
"ON"
average
"OFF"
daylight
"DAYL."
automatic
"AUTO."
Save changes / exit menu
Discard changes / exit menu
Explanation
Shows current temperature reading in two-colour
mode
Shows current temperature reading for L1
Shows current temperature reading L2
43
C020
)