OBH Nordica PRIME MIX Instruction Manual page 49

3. Blender jug 1.75 litres
4. Blade unit
5. Seal (not shown in illustration)
6. Lock ring
7. Motor section
8. Switch/speed knob
9. Programme selection buttons
10. Seal (not shown in illustration)
Use
Do not add ingredients with a temperature above 50 °C, and do not run the
appliance continuously for more than 3 minutes.
The blender can be used for blending, chopping, puréeing and mixing, e.g.
milkshakes and sauces. You can also crush ice for drinks, etc. Fit the blender
jug to the motor section after cleaning by first placing the seal around the
blade unit. Then place the blade unit in the base of the blender jug and then
screw the lock ring onto the blender jug. Make sure that the appliance is
switched off and then place the blender jug on the motor section so that the
lock ring fits into the slots on the motor section. Check to ensure that the jug is
straight and stable.
The blender motor moves the blade at high speed in order to guarantee
thorough mixing. It is important, therefore, that the blender is always placed
on a flat, dry surface before it is started. Also check that the blender jug is
correctly positioned on the motor section, otherwise the appliance will not start.
Remember to place the lid and filler cap on the blender jug before starting the
blender. Please note that, for safety reasons, the blender cannot be started
without the lid being correctly attached. The lid should enclose the spout of
the jug and be clicked firmly in place at the back edge by the handle. See
illustation 1for further explanation. Fill the blender jug with the ingredients to
be mixed (never exceed the maximum limit of 1.75 l) and place it on the motor
unit. Check that the speed knob is set to "OFF" and then plug the appliance
in. Turn the speed knob to "ON" (indicator lights come on) and then turn to the
required speed setting. Mix for a few seconds and then turn the speed knob
back to "OFF" and check the consistency. Continue mixing as required.
It is recommended that you try various speeds to work out what is best for the
ingredients you are mixing.
Never remove the blender jug from the appliance when the motor is running.