Specific Cleaning Procedures; Aluminum Housings - Omegasonics Viking PDX3 Operation & Instruction Manual

Drying (Tank 3)
 Any items that hold or "cup" any appreciable amount of water should be drained or
blown off via compressed air.
 Lower the basket, containing the contents to be dried, into Tank 3.
 Do not leave the lid open for extended times and this cause the heaters to remain on
for unnecessary long periods and this can shorten the life of the heater elements.
 After the timer has cycled off, open the lid, and remove the contents from the tank.

SPECIFIC CLEANING PROCEDURES

Aluminum Housings

 In the ultrasonic bath, preheat 1 part OmegaSupreme with 10 parts clean water to a
temperature of 125˚F.
 Wipe off the readily accessible, exterior excess from the parts to be cleaned.
 Arrange the parts so that no trapped air exits in the interior when lowered.
 Set the time for 2-5 minutes and start the cleaning cycle.
 If additional cleaning is needed, at the end of the first cycle, rotate the parts 180˚ in
the basket so that the portion that was facing the bottom of the tank is now facing
the top and vice versa.
 Clean the parts for another 2-5 minutes.
 When completed, rinse the parts with clean, hot water that is 125˚F.
 Blow off excess moisture using compressed air or a hot air blower.
20