Tank 3 - Omegasonics Viking PDX3 Operation & Instruction Manual

The quality of your water source can have an important effect on the performance of the
ultrasonic equipment. High levels of calcium, magnesium, sulfur and other contaminants
in the water source can have a negative effect on the type of cleaning soap used. High
levels of calcium and/or magnesium (constitutes hard water) can cause the soap to
work less efficiently and less effectively as intended and can also leave a white, flaky
residue on the parts once dried. If this white spotting occurs and is not desired, it will be
necessary to use soft water, drinking water or distilled water, in the machine. The level
of final cleanliness will dictate the water source used in the machine.

Tank 3

 Set the desired operating temperature. Factory preset is 160 ˚F.
 Set the desired Drying Cycle.
 Turn the Drying Cycle selector switch to the ON position.
 The red HEAT light will be lit when the heat has been turned on.
 There will be a two minute delay before the blower starts; this gives the heater time
to warm up.
 Allow approximately 5 minutes for the dryer to reach full temperature. The dryer is
designed to operate with the lid closed during the drying cycle.
*Note About Water*
12