Table of Contents
Advertisement
2.8.
Picture settings and Guide Lines
The picture settings are adjusted by the 3 buttons on the video-interface. Press the MENU
button to open the OSD settings menu or to switch to the next menu item. Press UP and
DOWN change the selected value. The buttons are embedded in the housing to avoid
accidental changes during or after installation. Picture settings must be done separately for
RGB, AV1, AV2 and CAM while the corresponding input is selected and visible on the
monitor.
Note: The OSD menu is only shown when a working video source is connected to the
selected video-input of the interface.
The following settings are available:
Brightness
Contrast
Saturation
Position H (horizontal)
Position V (vertical)
Guide CNTRL (ON
Note: If there is no communication between the CAN box and the vehicle`s CAN-bus
(several vehicles aren't compatible), the reverse gear guide-lines can`t be shown during the
vehicle's operation, even if they once appear after having switched the system to powerless!
Version 22.08.2018
HW CAM(V31)/(V22)
RL2-RLINK
Advertisement
Table of Contents
