Warning Notes, Concerning The Installation Of Ribbon Cables - r.LiNK RL2-RLINK Manual

2.4.1. Media Nav with 50pin Ribbon cable
Disconnect the optical leads housed between the monitor`s mainboard and the monitor-
panel. Connect the daughter PCB's ribbon cable
monitor`s mainboard. For this procedure you may either use the original ribbon cable or the
ribbon cable of the daughter PCB. Make sure that the connector pins of each pin connector
are faced to the platinum before clipping them.
Connect the ribbon cable
monitor's platinum (take care again for a platinum faced installation of the connector pins!)
Carefully fix the daughter PCB to the mainboard of the monitor by using the enclosed
spacers and screws
2.4.1.1.

Warning notes, concerning the installation of ribbon cables:

1) The contacting ends of ribbon cables always have to be installed in a straight and precise
180° position to the connector. Each deviation from a perfect contact position will curse
faulty contact and even danger of short circuit
2) The ribbon cable's contacting side always has to correspond to the contacting side of the
connector, concerning the mounting position.
Version 22.08.2018
CAR-IN
PNL OUT of the daughter PCB to the ribbon cable base of the
HW CAM(V31)/(V22)
to the ribbon cable base of the
RL2-RLINK